IAPMO IGC 100-2019
Copper Wrought Solder-Filled Joint Fittings
standard by International Association of Plumbing and Mechanical Officials, 2019
Side Navigation
X
IAPMO IGC 122-2005a (R2013)
Test Caps and Test Gates with ABS (Acrylonitrile-Butadiene-Styrene) or PVC (Poly Vinyl Chloride) Housings
standard by International Association of Plumbing and Mechanical Officials, 2005
IAPMO PS 106-2012
Pre-Fabricated, Tileable Shower Receptors
standard by International Association of Plumbing and Mechanical Officials, 05/01/2012
IAPMO IS 31-2014
Installation Standard for PEX Tubing Systems for Hot- and Cold-Water Distribution
standard by International Association of Plumbing and Mechanical Officials, 2014
IAPMO IGC 335-2018
Rapid Scaling Test for Scale Prevention Devices
standard by International Association of Plumbing and Mechanical Officials, 2018
IAPMO IGC 348-2017e1
Polypropylene Push Fit Drain, Waste, and Vent (DWV) Fittings
standard by International Association of Plumbing and Mechanical Officials, 2017
IAPMO PS 34-2019
Encasement Sleeves for Potable Water Pipe and Tubing
standard by International Association of Plumbing and Mechanical Officials, 2019
IAPMO IGC 234-2016
Demand Driven Storm Water Diversion Systems
standard by International Association of Plumbing and Mechanical Officials, 2016
IAPMO TS 13-2014
Water Fill Caps for Recreational Vehicles
standard by International Association of Plumbing and Mechanical Officials, 2014
IAPMO IGC 297-2013a
Pressure Relief Valves for Hot- and Cold-Water Distribution Systems
standard by International Association of Plumbing and Mechanical Officials, 12/01/2013